Hi,
I have a Creda T632CW dryer and at the moment I just can't get my head round the problem that I have with it. Over the past few years I have replaced the thermostats when there was a lack of heat on two occasions.
Now the damn thing is heating the elements when it is in the Sensor Mode and 30 minute mode but with power still applied and the drum not turning. It is only off when the knob is actually turned to off. It is working fine in both modes when the drum is turning.
Does anyone know where to start with this? I am thinking that it can't be the thermostats again. At the moment it is a bit of a fire hazard and I can't leave it running unattended.
Would appreciate any info on this and where to go next.
Many thanks
I have a Creda T632CW dryer and at the moment I just can't get my head round the problem that I have with it. Over the past few years I have replaced the thermostats when there was a lack of heat on two occasions.
Now the damn thing is heating the elements when it is in the Sensor Mode and 30 minute mode but with power still applied and the drum not turning. It is only off when the knob is actually turned to off. It is working fine in both modes when the drum is turning.
Does anyone know where to start with this? I am thinking that it can't be the thermostats again. At the moment it is a bit of a fire hazard and I can't leave it running unattended.
Would appreciate any info on this and where to go next.
Many thanks
