Does anyone have any advice please. About to fit a shower screen to end of bath but the wall where the screen will be mounted is about 4 tiles high then painted wall. The fixings would have to go into the tiles at the bottom (as they finish in line with the side of the bath) but the higher fittings would be into the wall which is some 4 or 5 mm further back than the tiles.
I think it's too much of a gap to fill with sealant, does anyone suggest a filler strip or does it look like continuing the tiles upward to maintain the same level. ?
thank you
I think it's too much of a gap to fill with sealant, does anyone suggest a filler strip or does it look like continuing the tiles upward to maintain the same level. ?
thank you