Hi. After seeking advice on here I have opted for a surrey flange to connect the hot water feed to my new shower pump.
The surrey flange comes with a male thread to screw into the top of the cylinder which looked on the web is typical.
The problem is my tank appears to have a male thread as existing so I am trying to connect to males together??
Any ideas what I should do?
The surrey flange comes with a male thread to screw into the top of the cylinder which looked on the web is typical.
The problem is my tank appears to have a male thread as existing so I am trying to connect to males together??
Any ideas what I should do?
