OK, I've just got off the phone with Mark, he has been down and replaced my DHW diaphragm (which had a hole in it) and the microswitch is now activating when the tap opens as expected, BUT , the DHW now overheats as it was doing before.
It comes on when tap opens, runs for 10 seconds, you can hear it starting to boil, then the overheat sensor kicks in and the burner cuts out.....for a couple of seconds....till it cools.... then it starts up again .....etc etc etc
Could there be a blockage somewhere ?
Could the heat exchanger be bunged up ?
Anyone got any ideas / or seen this before ?
OK ... Time to try removing the router from the equation....try unplugging the LAN cable from your router and plugging it straight into the laptops lan connector.
Set the desktops IP manually to 192.168.1.1
Set the laptop to obtain automatically ( on Local Area Conn)
Can you ping each other, can you see both in network neighbourhood.
Set the laptops IP manually to 192.168.1.1 (on Local Area Conn)
Set the desktop to obtain automatically
Can you ping each other, can you see both in network neighbourhood.
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local
