Heatline Sargon Noise!!!!

[Livesgas]

Installed the new Sargon 35 yesterday, what the hell is going on?! Sounds like its about to take off to fu**in mars! The premix SIT fan vibrates like hell and makes a low frequency drone on slowing to low load. Talked to the local heatline guy today who said "its a noisyboiler".
Why is there no sound deadening material?

 

[mehran]

It's a noisy boiler

some of the noise could be from it not been set up right. make sure the co2 is set up correctly. but you are right it is a loud boiler. the sargon replaced the old solaris. the solaris was not a quiet boiler in the first place but the new sargons really takes the biscuit.

I have fitted plenty of the solaris but I doubt will fit this new version unless it is well out of ear shot

btw it is fime fan...

sound deadening material would nice and maybe a air snorkel for the fan. It's a real shame, really could of been better...

 

[Livesgas]

The old Solaris used to whistle a bit but the Sargon is howling!
The Solaris fan was FIME but yesterday after checking the Sargon fan there was the SIT stickered logo on the top right.

 

[Livesgas]

Checed all the settings and all good apart from the ignition fan speed. Had to increase it to stop the low ignition drone noise.

 

[Agile]

What was the CO² on minimum power?

Tony

 

[Livesgas]

Ther are pots for "ignition capacity" (which i had to adjust to prevent ignition noise) , central heating capacity along with hot water. The inlet pressure was 19mb and CO to CO2 ratio 0.000. Sorry if a few mistakes as its late friday and the beers been flowing.