Hi,
I'm replacing my Drayton RTS1 stat with a Heatmiser PRT-TS Wifi.
All wired up correctly per Heatmiser's instructions and the new stat is powered up, recording temp and able to be programmed fine. However, when it makes a call for heating there is no activity at the boiler end (a Gloworm Micron via a Drayton LP241). The LP241 is set with CH permanently on.
If I switch back to the RTS1, the call for heating is answered, which leads me to conclude I've either got a faulty Heatmiser or there's some compatibility issue between the Heatmiser and the LP241.
Any ideas?
Cheers
Steve
I'm replacing my Drayton RTS1 stat with a Heatmiser PRT-TS Wifi.
All wired up correctly per Heatmiser's instructions and the new stat is powered up, recording temp and able to be programmed fine. However, when it makes a call for heating there is no activity at the boiler end (a Gloworm Micron via a Drayton LP241). The LP241 is set with CH permanently on.
If I switch back to the RTS1, the call for heating is answered, which leads me to conclude I've either got a faulty Heatmiser or there's some compatibility issue between the Heatmiser and the LP241.
Any ideas?
Cheers
Steve