Hi All....Frustrated of Hampshire here...
I have a Honeywell CM727 Programmer and have fitted a new relay unit, an HC60NG.
All is well with flashing lights and digital screens but they're like a couple of petulant kids and wont talk to each other. The HC unit goes into binding mode but I've no idea how to get the 727 unit to enter the right mode to get it to recognise the relay receiver so it can start working. The relay unit works on the button and the controller seems to be kicking out a signal - at least the transmission symbol flashes on when I manually raise the set point.
Does anyone know how to get them to communicate?
Regards,
Crick
I have a Honeywell CM727 Programmer and have fitted a new relay unit, an HC60NG.
All is well with flashing lights and digital screens but they're like a couple of petulant kids and wont talk to each other. The HC unit goes into binding mode but I've no idea how to get the 727 unit to enter the right mode to get it to recognise the relay receiver so it can start working. The relay unit works on the button and the controller seems to be kicking out a signal - at least the transmission symbol flashes on when I manually raise the set point.
Does anyone know how to get them to communicate?
Regards,
Crick