Hi
So I have a Honeywell G2-12 Panel which I had connected a C077 RF Portal which I have been using with a TCC8M on V2 mode as this is what the C077 supports and always been able to set/unset the panel without any issues.
I have now upgraded the C077 to the C079 (dual protocol) so I can add some wireless sensors, and I have also changed the TCC8M wireless keyfob to Alpha mode.
When I press any of the buttons I just get the single red light come up for the button pressed. If it press it about 3 or 4 times it will eventually register and flash about 6 times and system set/beep to rspond to action.
I have tried re-enrolling the wireless fob which was successful, but the issue remains.
Any ideas why this would be happening??
Thanks in advance
So I have a Honeywell G2-12 Panel which I had connected a C077 RF Portal which I have been using with a TCC8M on V2 mode as this is what the C077 supports and always been able to set/unset the panel without any issues.
I have now upgraded the C077 to the C079 (dual protocol) so I can add some wireless sensors, and I have also changed the TCC8M wireless keyfob to Alpha mode.
When I press any of the buttons I just get the single red light come up for the button pressed. If it press it about 3 or 4 times it will eventually register and flash about 6 times and system set/beep to rspond to action.
I have tried re-enrolling the wireless fob which was successful, but the issue remains.
Any ideas why this would be happening??
Thanks in advance