I've just got a howdens kitchen and am about to fit the plastic adjustable legs, the part that attaches to the base cabinet has 4 screw holes and is a circle shape with 2 sides of the circle cut straight.
The howdens manual says the one of the flats must face the front of the cabinet and part of the flange should carry the end panel.
That sounds fine but firstly if i did this the end panel would only be supported by 2-3mm of the flange & because the end panels stick down 1mm lower than the base fixing face, it angles the leg over to one side.
The picture in the manual doesn't even show an end panel.
Which is the correct way?
The howdens manual says the one of the flats must face the front of the cabinet and part of the flange should carry the end panel.
That sounds fine but firstly if i did this the end panel would only be supported by 2-3mm of the flange & because the end panels stick down 1mm lower than the base fixing face, it angles the leg over to one side.
The picture in the manual doesn't even show an end panel.
Which is the correct way?