Morning all,
My water cylinder is an Economy 7 Direct (two immersions) the bottom immersion is fed form an economy 7 supply and the upper immersion works off my normal supply.
Yesterday I fitted a brand new cylinder / 2X Immersions and an economy 7 Hortsman timer; although the top immersion works fine, this morning the bottom immersion tripped. Why??
On the economy 7 feed I also have three large Duplex storage heaters - is this too much?
When I bought the house 10 years ago the above was the original set up and worked fine, all I have done is replaced on a like for like basis.
Any ideas on how I can stop the economy 7 fed immersion from tripping?
My water cylinder is an Economy 7 Direct (two immersions) the bottom immersion is fed form an economy 7 supply and the upper immersion works off my normal supply.
Yesterday I fitted a brand new cylinder / 2X Immersions and an economy 7 Hortsman timer; although the top immersion works fine, this morning the bottom immersion tripped. Why??
On the economy 7 feed I also have three large Duplex storage heaters - is this too much?
When I bought the house 10 years ago the above was the original set up and worked fine, all I have done is replaced on a like for like basis.
Any ideas on how I can stop the economy 7 fed immersion from tripping?