Hi There
This appliance (IDL40 dishwasher) is merely 17 months old and as the title will show this is our second in quick sucession.
I would appreciate any suggestions before I attempt to call out the engineer as this has become quite expensive
There is no digital display on this model - so no error codes. However from left to right the first and third light flashed simultaneously. I checked the filters as this was what the manual indicated but they were clean. Lights went off I assumed it was a 'blip'
However on susequent run I opened the machine and noticed half the element was exposed and glowing red hot as it was not covered with water.
Main water pressure fine. Tonight I will check inlet hose to make sure it is not kinked or full of limescale.
My questions are - surely the machine should cut out if there is insufficient water in the appliance before heating?
Why was only the back right hand part of the element exposed. The casing is level ?
Indesit recomend an engineer visit and can't advise call out is 104 pounds so I would like to be sure that I need it
Any suggestion are greatly appreciated. Not very sure where to start with this
many thanks in advance
This appliance (IDL40 dishwasher) is merely 17 months old and as the title will show this is our second in quick sucession.
I would appreciate any suggestions before I attempt to call out the engineer as this has become quite expensive
There is no digital display on this model - so no error codes. However from left to right the first and third light flashed simultaneously. I checked the filters as this was what the manual indicated but they were clean. Lights went off I assumed it was a 'blip'
However on susequent run I opened the machine and noticed half the element was exposed and glowing red hot as it was not covered with water.
Main water pressure fine. Tonight I will check inlet hose to make sure it is not kinked or full of limescale.
My questions are - surely the machine should cut out if there is insufficient water in the appliance before heating?
Why was only the back right hand part of the element exposed. The casing is level ?
Indesit recomend an engineer visit and can't advise call out is 104 pounds so I would like to be sure that I need it
Any suggestion are greatly appreciated. Not very sure where to start with this
many thanks in advance