After being let down by 4 plumbers now, I'm thinking of of tackling the pipe work myself. (not gas).
I had helped a mate fit his, some 20 years ago (copper/soldered), so I'm familiar (if not rusty) with the concept, but wondered if the process has changed in that time.
I was going to install flow and return in 22mm copper (as done before) but someone mentioned just use plastic, and, the bits that show in copper.
Can anyone recommend a make of plastic pipe that would be suitable, as I'm not up to speed with this.
I see you can buy lengths or coils, is one preferable over the other? or should you buy both?
TIA
I had helped a mate fit his, some 20 years ago (copper/soldered), so I'm familiar (if not rusty) with the concept, but wondered if the process has changed in that time.
I was going to install flow and return in 22mm copper (as done before) but someone mentioned just use plastic, and, the bits that show in copper.
Can anyone recommend a make of plastic pipe that would be suitable, as I'm not up to speed with this.
I see you can buy lengths or coils, is one preferable over the other? or should you buy both?
TIA