I wish to install a 6way MCB Consumer Unit in an older house that has been rewired within the last 10yrs, but the distribution board was not replaced.
I have a qualified industrial Electrician friend that will carry out the work. However the Main Fuse needs pulling to disconnect the tails and reconnect to the new unit.
How can I get the Main Fuse pulled (seals cut) and reconnected on completion without providing a Certificate of conformance to the new reg's. Clearly I do not wish to rewire the complete house at this stage.
Any views or pointers on procedure I could adopt?
Plonker
I have a qualified industrial Electrician friend that will carry out the work. However the Main Fuse needs pulling to disconnect the tails and reconnect to the new unit.
How can I get the Main Fuse pulled (seals cut) and reconnected on completion without providing a Certificate of conformance to the new reg's. Clearly I do not wish to rewire the complete house at this stage.
Any views or pointers on procedure I could adopt?
Plonker