- Joined
- 12 Dec 2016
- Messages
- 448
- Reaction score
- 3
- Country
Made a box for pump and controller- I used batons to hold sides together, is this the best way? I found the sides weren't exactly at 90 degrees, how can you make sure they don't slightly come in at a bit of an angle?
When I put hinges on the the screws were a bit long for the 10mm ply door so I tried cutting 2 1mm packers to go under hinge but still felt the 10mm wasn't strong enough so in the end I used screwed on some wood the front and used longer screws, is 10mm too thing for hinges to go into
When I put hinges on the the screws were a bit long for the 10mm ply door so I tried cutting 2 1mm packers to go under hinge but still felt the 10mm wasn't strong enough so in the end I used screwed on some wood the front and used longer screws, is 10mm too thing for hinges to go into