I have recently installed a ESP 50 CPV Salamander pump to boost the water pressure to the shower and taps.
The system is 'in-direct' and 1m head between CWT and shower head at best as we are in the top flat.
I have installed the hot water feed by way of an Essex valve in the side of the HWC and we are now getting a good flow of HW & CW @ all taps but the HW does not reach the shower head?????
The shower is fed through an Aqualisa tap fitting with integrated shower mixer. I have had 1 hot shower once i commisioned the system by no long duration since even after re-commisioning the HW side?
Also i initially installed a CT 50+ within the same system and DID have a fully operational system. I upgraded to the more advanced pump on Salamander 'Pumpwise's' recommendation due to the requirement for the whole flat to be serviced by the pump..... Wish i hadn't bothered now!!!!
Why could this be happening????
Please help......
The system is 'in-direct' and 1m head between CWT and shower head at best as we are in the top flat.
I have installed the hot water feed by way of an Essex valve in the side of the HWC and we are now getting a good flow of HW & CW @ all taps but the HW does not reach the shower head?????
The shower is fed through an Aqualisa tap fitting with integrated shower mixer. I have had 1 hot shower once i commisioned the system by no long duration since even after re-commisioning the HW side?
Also i initially installed a CT 50+ within the same system and DID have a fully operational system. I upgraded to the more advanced pump on Salamander 'Pumpwise's' recommendation due to the requirement for the whole flat to be serviced by the pump..... Wish i hadn't bothered now!!!!
Why could this be happening????
Please help......