Hi
I have a verandah (used 90% of time) on zone 1
Front door on zone 2
since changing front door it is now in use more but goes into alarm state when we enter the property.
I have reset it at "prog, 1, 4, 1 but it goes off immediately.
I would like to leave zone 1 (the verandah) as zone 1 and sort out this front door zone 2.
ALSO, a further problem while I am here:
On entering the verandah it counts down the 30 seconds, but opening second door (zone 4 where control box is) it goes into alarm status.
Yet I used to have a time to walk in both doors and key the code in.
appreciate help guys please
I am a, long in the tooth tradesman but seem to be getting forgetful and can not remember how I have managed to cock it up as it was fine when I replaced the whole lot a couple of years ago
thanks
I have a verandah (used 90% of time) on zone 1
Front door on zone 2
since changing front door it is now in use more but goes into alarm state when we enter the property.
I have reset it at "prog, 1, 4, 1 but it goes off immediately.
I would like to leave zone 1 (the verandah) as zone 1 and sort out this front door zone 2.
ALSO, a further problem while I am here:
On entering the verandah it counts down the 30 seconds, but opening second door (zone 4 where control box is) it goes into alarm status.
Yet I used to have a time to walk in both doors and key the code in.
appreciate help guys please
I am a, long in the tooth tradesman but seem to be getting forgetful and can not remember how I have managed to cock it up as it was fine when I replaced the whole lot a couple of years ago
thanks