I have a new kitchen fitted and have installed pelmet lighting under the wall mounted units.
I have used the existing wiring (feed) which is 1mm twin/earth,The lights are 13 watt & 15inch long & interlinked with 1mm 3 core flex.the light switch is 2 gang brushed chrome. the problem that i have is that when the light are switched on they work but if you swicth off then on again they trip out and have burned the cable at the connection to the first light.it has also blackened the cable at the light switch.
I have disconnected all wiring as a safety measure.
Have you any ideas as to what could be causing this.
I have used the existing wiring (feed) which is 1mm twin/earth,The lights are 13 watt & 15inch long & interlinked with 1mm 3 core flex.the light switch is 2 gang brushed chrome. the problem that i have is that when the light are switched on they work but if you swicth off then on again they trip out and have burned the cable at the connection to the first light.it has also blackened the cable at the light switch.
I have disconnected all wiring as a safety measure.
Have you any ideas as to what could be causing this.