I have just bought a 2005 pug.
But the bodywork is all pretty good apart from the front O/S wing. That is quite rusty and has obviously been replaced carelessly at some point. So a few questions.
When new, how were the panels joined?
How best to remove a maker's panel?
When the replacement was fitted how will that have been fitted?
How best to remove the replacement fitted panel?
How to fit a new after market one?
How to fit a used panel?
Thanks
Tony
Edit: slightly edited because I realised that I have a panel I can use on a car due to be scrapped!
But the bodywork is all pretty good apart from the front O/S wing. That is quite rusty and has obviously been replaced carelessly at some point. So a few questions.
When new, how were the panels joined?
How best to remove a maker's panel?
When the replacement was fitted how will that have been fitted?
How best to remove the replacement fitted panel?
How to fit a new after market one?
How to fit a used panel?
Thanks
Tony
Edit: slightly edited because I realised that I have a panel I can use on a car due to be scrapped!
Last edited: