Hi all,
Cut a rafter to 10 degrees, offered up to wall only to find the existing house wall is out of level.
My question is for every rafter that is out on the plumb cut should I make an adjusting cut so that the rafter sits square to the existing wall as opposed to just the tip of the timber touching the wall?
Top of rafters to existing house wall will be birdsmouth cuts to wallplate, just doing a test cut on the timber.
Thanks in advance,
Paul
Cut a rafter to 10 degrees, offered up to wall only to find the existing house wall is out of level.
My question is for every rafter that is out on the plumb cut should I make an adjusting cut so that the rafter sits square to the existing wall as opposed to just the tip of the timber touching the wall?
Top of rafters to existing house wall will be birdsmouth cuts to wallplate, just doing a test cut on the timber.
Thanks in advance,
Paul