Morning all.
Looking for a little advice regarding my Puma 80.
Its in a ground floor one bed flat. I recently, (about 3 weeks ago) had a problem where the pilot light would not come on, I got an engineer out who said the thermocouple had gone and replaced it. Things have been working fine, however I have noticed the system pressure which previously sat constantly at 1.5 bar is now up at 3 to 3.5.
I have reduced the pressure using the valve loop twice now back to 1.5 but within 24 hours its back up again. It rises as the CH is on then reduces slightly when it is turned off, but not back to the 1.5 level.
Boiler is about 10 years old, not sure if this is relevant or not.
Should I be worried? Any advice would be appreciated.
P.S I did a search but could only find low system pressure issues.
Thanks.
Graeme
Looking for a little advice regarding my Puma 80.
Its in a ground floor one bed flat. I recently, (about 3 weeks ago) had a problem where the pilot light would not come on, I got an engineer out who said the thermocouple had gone and replaced it. Things have been working fine, however I have noticed the system pressure which previously sat constantly at 1.5 bar is now up at 3 to 3.5.
I have reduced the pressure using the valve loop twice now back to 1.5 but within 24 hours its back up again. It rises as the CH is on then reduces slightly when it is turned off, but not back to the 1.5 level.
Boiler is about 10 years old, not sure if this is relevant or not.
Should I be worried? Any advice would be appreciated.
P.S I did a search but could only find low system pressure issues.
Thanks.
Graeme