- Joined
- 12 Jan 2006
- Messages
- 77
- Reaction score
- 1
- Country
I have puma 80, failed this week. I have followed fault finding chart and concluded that pump failed as it did not operate after boiler fired up. After short time boiler shut itself down probably overheat protection and pilot went out. I went to local merchant he sold me DAB VA 55 pump, my first mistake as this pump has 1 1/2 instead of 1 inch union. He said that head will fit but it can't fit over Myson CP61 pump. As I was removing old pump I also had managed to loosen up pipe that connects top of the pump with heath exchange box. To get to this I need to open this box but this is sealed compartment so I am not sure if I can open this. This is top of the boiler right hand side it has two small screws holding cover. The pipe bends above pump and comes along the side of the boiler and enters sealed unit at the right hand side.
Any advice on pump or how to fix loose pipe? or where I could get new CP61 or head in London N or NW. I have found some internet places but I would like to pick it up before weekend so I can have shower at last.
Thanks
Any advice on pump or how to fix loose pipe? or where I could get new CP61 or head in London N or NW. I have found some internet places but I would like to pick it up before weekend so I can have shower at last.
Thanks