Hi i have a new raven heat csi 85b(T) , it runs fine but it frequently ,(i think over heats) and switches off, the over heat / flame failure light comes on.
I have two radiators with non thermostatic valves so there should be constant flow.
This fault occurs with the central heating as well as after having a shower.
I keep turning the thermostats on the front down, but if i turn it to low it doesnt get the place warm enough. I have massive drafty sash windows, so the radiators need to belt out the heat.
I have read in the manual about adjust the gas potentiometer on the pcb, but im not sure what this will achieve.
Any suggestions.
thanks
Adrian
I have two radiators with non thermostatic valves so there should be constant flow.
This fault occurs with the central heating as well as after having a shower.
I keep turning the thermostats on the front down, but if i turn it to low it doesnt get the place warm enough. I have massive drafty sash windows, so the radiators need to belt out the heat.
I have read in the manual about adjust the gas potentiometer on the pcb, but im not sure what this will achieve.
Any suggestions.
thanks
Adrian