Hello,
I was hoping somebody could help me with the following: I have a scantronic i-on 40 panel and I'm trying to integrate it with some home automation stuff.
I need a couple of outputs to indicate set / part set status, so I thought I'd use a couple of the plug-by communicator outputs. The first output (OP/1) is set to 'Full Set" and the second output (OP/2) is set to "Part set". This works fine when I manually test the outputs, however the outputs don't become active when the system is part or full set.
Does anybody have any ideas?
Thanks in advance!
Stefan
I was hoping somebody could help me with the following: I have a scantronic i-on 40 panel and I'm trying to integrate it with some home automation stuff.
I need a couple of outputs to indicate set / part set status, so I thought I'd use a couple of the plug-by communicator outputs. The first output (OP/1) is set to 'Full Set" and the second output (OP/2) is set to "Part set". This works fine when I manually test the outputs, however the outputs don't become active when the system is part or full set.
Does anybody have any ideas?
Thanks in advance!
Stefan