I have just ripped out my living room ceiling, I can now see most of the upstairs heating circuit copper pipe work.
Most of the joints are very poor on the pipe work and they are all green and scaly on the solder rim.
This is the perfect chance now to reseal them with a better seal but I have no idea where to start.
Do I need to disconnect them and use new fittings?
Do I clean them up with wire wool then re solder?
Whats the best way to resolder?
Many Thanks
Most of the joints are very poor on the pipe work and they are all green and scaly on the solder rim.
This is the perfect chance now to reseal them with a better seal but I have no idea where to start.
Do I need to disconnect them and use new fittings?
Do I clean them up with wire wool then re solder?
Whats the best way to resolder?
Many Thanks