Suprima50 pcb fitted. Now no ignition

Joined
27 Nov 2005
Messages
2
Reaction score
0
Country
United Kingdom
Hi All. I have just replaced the old pcb with new improved variety 5111603. It now goes through start up routine up to flashing orange/green, the fan starts, but no ignition occurs. After a minute or so the fan stops and the led goes to flashing red 3 times/sec, indicating an APS problem. I notice that from the instructions, no earth is required to the fan??. I also did not remove the fan. What do I need to do now?
 
Sponsored Links
Couple of times I presumed I had pushed the ignition lead onto the pin on the back of the board but had actually missed...worth checking.
 
Sponsored Links
I would recon that you have got the pipes the wrond way around on the pressure switch
 
Thanx chaps, will check these out on next visit to girlfriends boiler, not that my girlfriends a boiler of any sort, but ........ why am I nexplaining this to you.
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top