Hi, I am looking to replace the existing basin tap tails in my new build house downstairs WC with tap tails that have an isolation valve built in but I am struggling a bit with the sizes. This is prep work for a bigger bathroom job. I have attached a photo for reference.
I measured across the threads of the brass male connector in the picture and it was 21mm so I am presuming this and the fact that it is a modern house mean I am looking for '22mm' tails?
Tap tails this size obvioulsy exist as there is one installed but I can't find them anywhere. All I am seeing are 10x15, 12x15 or imperial sizes.
Or is the answer to use the existing tails but use seperate isolation valves? If so, is there a type that would fit directly between the female flexi end and the existing male brass pipe connection?
Any help appreciated, apologies in advance if I am being thick.
I measured across the threads of the brass male connector in the picture and it was 21mm so I am presuming this and the fact that it is a modern house mean I am looking for '22mm' tails?
Tap tails this size obvioulsy exist as there is one installed but I can't find them anywhere. All I am seeing are 10x15, 12x15 or imperial sizes.
Or is the answer to use the existing tails but use seperate isolation valves? If so, is there a type that would fit directly between the female flexi end and the existing male brass pipe connection?
Any help appreciated, apologies in advance if I am being thick.
Last edited: