Hi,
Had a brand new shiny Vaillant Ecotec Plus 624 installed a couple of months ago after the last one packed in.
All working fine for Hot Water & Heating since then, however a couple of days ago the HW wasn't working in the morning.
Heating still works fine, but no HW. Have reset, turned off and on again and run the chimney sweep mode.
There's no error messages appearing anywhere, it's just like the boiler doesn't realise it has the ability to make hot water and doesn't acknowledge it all.
Assuming it's something v straightforward to switch given how new the boiler is...any tips!?
Thanks in advance.
Had a brand new shiny Vaillant Ecotec Plus 624 installed a couple of months ago after the last one packed in.
All working fine for Hot Water & Heating since then, however a couple of days ago the HW wasn't working in the morning.
Heating still works fine, but no HW. Have reset, turned off and on again and run the chimney sweep mode.
There's no error messages appearing anywhere, it's just like the boiler doesn't realise it has the ability to make hot water and doesn't acknowledge it all.
Assuming it's something v straightforward to switch given how new the boiler is...any tips!?
Thanks in advance.