evening all.
I am looking to create a rather long worktop run using 38mm thick, 600mm deep laminate worktop.
Its going to be in excess of the maximum length this particular worktop comes in.
My question is, how would you guys suggest I join the two lengths?
A male/female scribed joint using a worktop jig and worktop bolts as you would do in the corners? or just butt the two straight edges together and use worktop bolts?
thanks in advance.
jim
I am looking to create a rather long worktop run using 38mm thick, 600mm deep laminate worktop.
Its going to be in excess of the maximum length this particular worktop comes in.
My question is, how would you guys suggest I join the two lengths?
A male/female scribed joint using a worktop jig and worktop bolts as you would do in the corners? or just butt the two straight edges together and use worktop bolts?
thanks in advance.
jim