hello guys..
I've got Yale alarm system.
One PIR flashed red and the control unit said it needed new batteries.
I went and bought rechargable batteries, I fully charged them, each are 1.2v
I put them in the PIR, It flashed fast for 30 seconds then I mounted it.
I tried the walk test and found it detected me but from close range.
After I disarmed the system, I noticed the PIR flashes red whenever I pass by it. This usually happens when the PIR needs batteries, but the Control unit didn't show any fault!
I removed the PIR from the system and added it again, but it still flashes red whenever I pass by it.
Other PIRs don't flash red when someone pass by them.
Could you please advise?
I've got Yale alarm system.
One PIR flashed red and the control unit said it needed new batteries.
I went and bought rechargable batteries, I fully charged them, each are 1.2v
I put them in the PIR, It flashed fast for 30 seconds then I mounted it.
I tried the walk test and found it detected me but from close range.
After I disarmed the system, I noticed the PIR flashes red whenever I pass by it. This usually happens when the PIR needs batteries, but the Control unit didn't show any fault!
I removed the PIR from the system and added it again, but it still flashes red whenever I pass by it.
Other PIRs don't flash red when someone pass by them.
Could you please advise?