texecom premier elite 24, n/c n/o relay options???

[933tomcat]

Guys, Any ideas would be of a great help please....

I am looking to add on some n/o & n/c relay options to run some ancillary devices, can the texecom rm8 be hardwired and if some how would you wire to the board????...

Thanks ever so much

 

[secureiam]

The RM8 can be hard wired to any panel.

12V power from the panel and wire the outputs to the output side of the relay module or 12V supply with a common neg back to the panel.

There are full instructions with the product I believe it has been a while since I used one.

 

[933tomcat]

o.k.... thanks.. so we can hook up panel outputs etc but any ideas on the supply input to run the board I can't see this aspect in any images... it is 12v aux in anywhere????

 

[secureiam]

look at the images again if its not there drop the tech support an email

I havent used one for a long tine

 

[sparkymarka]

It's at the end of the board after the 8 relays....

 

[933tomcat]

I just had a look at the rm8 manual and it shows the two pins at the end as 12v output... Only inputs I can see is channel switch input. Any ideas, would be grateful