Property marking pen Use a permanent marker to identify property, and make sure you keep a list of serial numbers and any other identifying features. For more unusual items, photograph as part of your security procedure. Items should be marked with your name and postcode. Invisible identification marks can be made on items using a […]
Property marking pen Read More »
Displaced Flashing If the section of flashing has come away, usually at the top, it can be easily repaired. Remove any crumbling mortar and clean the area with a brush. Tap the flashing back into position with a hammer. Use small strips as wedges to help hold the flashing in position. Repair the area with
Repairing metal flashing Read More »
Polystyrene tiles Polystyrene tiles, often used to cover ceilings can be covered with emulsion paint once the surface has been cleaned with sugar soap and water and dried. Often this kind of tile is removed and the complete surface redecorated with either paper, paint or a different tiling. See Removing polystyrene tiles for more details.
Installation The washing machine must be level and all four feet should be in firm contact with the floor. Each foot is adjustable but normally it is only necessary to adjust one of the front feet to achieve stability. Failure to make the washing machine level may affect stability and vibration. Use a spirit level
Installing a washing machine Read More »
Method If the surface is already covered with emulsion, clean the surface with sugar soap and water. If the surface is uneven and worn in places, it may be advisable to remove the paper and redecorate first. Refer to Removing wallpaper for more details. It may be possible to wipe the surfaces with a damp
Preparing Walls and Ceilings Read More »
Preparing the surrounding brickwork The new frame will not require extending into the brickwork, so fill those gaps with a cement mortar mix. Under the bottom (the sill) there should be evidence of a damp proof course. Check the condition of the damp proof course and replace it if there are any signs of damage.
Fitting the new exterior door frame Read More »
Reasons to replace an external door There can be many reasons for deciding to change an external door apart from it needing repair or re-painting. The fitting may be poor allowing draughts to enter the house, through gaps at the bottom or sides of the door. The door could be unfashionable and in a poor
Choosing an exterior door Read More »
Reasons to replace a window There can be many reasons for deciding to change a window apart from it needing repair or re-painting. The fitting may be poor allowing draughts to enter the house, through gaps at the bottom or sides of the window. The window could be in a poor state of repair, squeaking
Washable Fabrics Immerse at once in cold water. While soaking, dissolve washing up liquid in the water, at the same time rubbing the area with your fingers. If this does not remove the stain, soak in a biological detergent in warm water. Should the stain persist, sprinkle borax on the mark and flush with water
Introduction Depending on the type of shower that you wish to install, the shower head must either be fitted in order to prevent it coming into contact with the water in the bath below or the base tray, or it must have a check valve. Preparation First and foremost you must decide on the type
Installing a shower Read More »
