I've attached a photo of the zone valve (upstairs one is yellow coded) and it's route into the wiring centre. I've also attached a close up of a cable with brown/blue wires entering the centre, might this be the same cable that's connected to the Danfoss stat in the bedroom?
Over to you chaps...
No problem locating the wiring centre, but the innards look like spaghetti junction. I wouldn't know where to start. Time to call in the experts methinks.
You've lost me. This Hive single channel receiver and separate thermostat is replacing the Danfoss which currently controls Zone 2 of our heating, i.e upstairs.
Bit of help needed please peeps!
My mate and I successfully installed a two channel Hive for hot water and heating but he's gone off on hols! Now I need to install the upstairs single channel Hive for controlling just the heating but I'm a little confused on the wiring. I'm replacing a Danfoss...