Recent content by 5parks

  1. 5

    Need to put up a Light in the bedroom.

    Firstly make sure your hands are dry after your plumming efforts, turn off the mcb that supplys this lighting circuit. its really straight forwad these ceiling roses are made up of 3 connecter blocks basically. the reds in the middle are your permant lives and need to go on their own in a...
  2. 5

    advise on possible downlight fitting please ?

    He could fit fire rated down lights though, the ones I fit made by jcc comply with 30 mins, 60mins and 90 mins, and they have an acoustic seal something else to bear in mind. Two nice fittings would be better though
  3. 5

    Garage Consumer bust following buliding work.

    If not, turn off the mcb that supplies the shed and get a sparks in to check your swa to the shed and your internal wiring(shed)
  4. 5

    Garage Consumer bust following buliding work.

    Have you checked that your getting 240v at the top of your main switch (the supply from the house)?
  5. 5

    NVQ 3

    That's a good idea to get you started, get yourself a hi viz and hard hat and go to town on it. Wish you were down south I could do with some free labour
  6. 5

    Big or small electrics job?

    High reading on the sockets could be loose connection dodgy junction box could be big can of worms
  7. 5

    Big or small electrics job?

    Doesn't sound too bad no re-wire recommended? I would suggest a new fuse board and the jobs listed you would be looking at £600-£800 at guess. Main earth under sized- but then means of earthing not determined?? Or was that a piticular circuit?
  8. 5

    Bathroom Extractor fan.

  9. 5

    Bathroom Extractor fan.

    You could get an electrician to replace your 40a fuse with a 6a and then run a 1mm t&e from the load side of your pull cord to the fan. Not ideal and I wouldnt do it but then this is a diy forum and that would be a typical diy solution.
  10. 5

    Bathroom Extractor fan.

    Your best bet is to get an electrician in to wire one in properly for you off the lighting circuit. This way you can have a fan with an over run on it. You would struggle to fit a 6mm/10mm cable in the fan connections any way. Get it done properly is the answer
  11. 5

    Should i be worried.

    It certainly wouldn't hurt to tidy it up, looks a bloody mess
  12. 5

    Shaver socket for toothbrush

    That's that
  13. 5

    Shaver socket for toothbrush

    Outside zone 2 will be fine so long as you have rcd protection, you can use a switched fcu outside zone 2.
  14. 5

    Transformers

    Get your new transformers and a new electrician to fit them, this bloke sound a waste of time and your money.
Back
Top