Recent content by 88cookie

Any advice on what route to take?

it runs then stops then runs then stops. Hot water set to 55 degrees mate. Killing me this one nothing I could have seen before hand unless I could look through walls. I will try those options. Pressure reducing valve set to 2 bar, same as pumps output. Same for both showers. What if it’s back...

Yea the pump is stop start. It does get tricky but it’s how the system is and customer is limited. It’s a stainless steel cylinder. Didn’t think you could put an Essex flange on seconds outlet

Hi, I’ve installed a single impella neg head bronze pump on hot outlet. It feeds 2 new showers and a few other outlets. Top floor bathroom not of pump. The system hasn’t been done well before hand and I’m going off what’s there. Pump is now installed of secondly feed at tank etc, I then...