Recent content by a12tfp

Would you credit it?! Everything was fine for maybe an hour, then off it went! I've had a wiggle of the arm and notice there's a second small black slider arm (?) on one side of the unit. It's got 3x letters, M, W and not sure what else, even if that's accurate, as it's almost flush up against...

Well, we seem to have heat! In all the rads. I had fiddled with the arm on the valve as you'll be aware from the previous postings, but also, I'd read about returning the Digistat back to its original factory settings on this forum. So, whatever did the trick, it's worked & we now have a...

I may have done this incorrectly. On further inspection, and this is with both the c/h on & off, the arm does move back under a spring (?) tension but it's everso slight and the same amount , be it on or off. It's an ACL Lifestyle - I have some pictures if it'd help.

Sadly it's an ACL, so I guess we're looking at what, draining the system and replacing the whole unit?

Yes! It's not giving any resistance and moves left - right freely with the c/h off. Do I buy some Viagra to assist the valve or do I replace it in its entirety?

Good stuff. I'll go and have a look. Thanks

Here’s a problem for all you problem solvers! I have central heating that’s a sealed system, a 2 way valve (?) with a timer upstairs in the airing cupboard which is also where the hot water tank and expansion cylinder are sited. Downstairs in the hall there’s a Drayton Digistat3 controller...