I think my measurement for the waste pipe in the wall didn't account for the end of the old pan connector still attached to the pipe as it only measured just over 90mm and the connector I've seen is 110
Yes I was hoping to replace the existing flush system that has 2 rods from the button to something newer that has the cable attached to the push button..
The pipe on the wall , there is no room for movement really as it looks pretty well stuck firm.. The connector I guess will just slot inside...
Thanks for the helpful replies again guys.. I've never done anything like this before so all comments appreciated.. OK so the waste pipe looks like the pic attached.(apologies in advance, tbf not as bad as I thought, definitely no smells, lol) .i think the toilet literally slotted into the hole...
Thanks mate.. I'll probably do that as wel .. Does anyone know of any way I can replace the dual flush rod type with the newer plug in button type. The issue I've got as mentioned earlier is that the flush button hole is rectangular and all the newer push buttons are all round..if I get the...
OK finally managed to get the cistern off the wall with a lot of elbow grease and my wife's carving knife.. So there was adhesive holding the cistern onto the pan as well! So a bit of advice from you experts. I need to replace all the inside with a 2 in dual flush (rod type) and the inlet...
I can't get a hand saw down from the top.. I'll see if I can get it from the sides and try the oil method you mention .. Will any oil do or machine oil?
I'm struggling to get the cistern off the wall I've used the blade from a hack saw to try and cut away at the pva or whatever is holding the cistern to the wall but not having much success.. I've removed the screws holding the toilet to the floor and there is a bit of movement when I pull at the...