The one installed in in landing area near the light and switch is kept in ON position and taped so that no one can turn it off. As soon as a motion is detected, the light turns on. Same way i want to use the sensor in downstairs hall way. we always forget to turn off the lights and sometimes...
Hi
I'm trying to install PIR motion sensor in 2 different places in my house. One in landing area where there is only one light. However, in our hallway there are 2 lights with 2-way switches. I'm confused with the wiring of which wire connects to which and all the wiring is concealed. I've...
Hi CBW
Hope all is good. Back to continue the project. I've left it in the middle due to other priorities.
Please see the attached pictures.
1. Myson Room Thermostat (MRT1) Circuit diagram
2. Wiring picture (pin4 - Grey wire from the wall; pin3 - Black wire from the wall and black wire from...
Hi CBW
Thanks for the reply and apologies for the delay in replying. I'll be replacing the current controller and Thermostat again tomorrow. So as to know, you said it's the live and switches wires to join together. which are the first two cables (Grey and Black) or the first and the last (Grey...
Hi CBW, thanks for the reply. No other alterations were made. I've reverted back to old controller and old thermostat as to the need of some heating and hot water. With the old equipment, all working fine.
Which wires i need to join after removing the old thermostat/ Please advise.
Thanks &...
Hi Guys
I'm new to this forum. So, please excuse me if this post is already discussed / not relevant.
We have a gas central heating with boiler in the kitchen and a water tank in a cupboard upstairs. Heating and hot water control with a controller and a normal Honeywell Thermostat. I've...