Recent content by aerochago

No cant raise the roof, its a black felt roof.Possibly considered lowering the ceiling, there is a thin layer of fibreglass insulation only above the original ceiling.

Our lounge extension built in 1973 has a flat roof and very poor ceiling insulation, its cold in the winter and hot in the summer and you can hear seagulls padding about and rain drops falling. We want the original ceiling replaced anyway so what thickness of Celotex would be suitable. 100cm has...

I remember some years ago it was mentioned that heating up the edges with a blowlamp and brush a diluted pva mixure in was a ggod idea, was that so? Alan

What is best treatment for exposed edges on tanalised ply, its going to be the baseboards on garden railway and covered with mineral felt. Regards Alan

What about the areas where the plaster has a rough finish higher up on the walls will that seal there? Alan

Our bungalow was built in 1933 and its about twelve years since i last stripped the paper off in the bathroom. We have always suffered with condensation and mould especially round and under the cistern. Higher up on the walls they are not so smooth now and rough to the touch in places. I want to...

Been using this for sometime but only occasionally and its just died, any issues with these? Alan

Well pcb is fitted and aok atm Cheers al :lol:

Fella from Heateam came over and found that when I explained to him what the problem was he said "it should'nt do that". Anyway worked out it was some malfunction in the pcb so got one on order to be fitted this week. I will keep you posted Alan :roll:

Thanks yes I will phone tomorrow Al

Hi, Had this boiler installed in April, so far engineers been here three times to sort out noisy intermitent ignition and have eventually replaced the electrodes and gas valve.Thats seemed ok but on Sunday woke up to boiler going full bore and rads piping hot. I turned the thermostat down which...