Recent content by afclucas

pump and boiler both turn off, valve for CH heating shuts but the HW is still open.

Cheer mate, I've wired it to the diagram, I've put a pic on does it look right if you can tell? The valves and pump seem to be working the boiler has fired up when switch on for CH. still not getting anything to the rads though. Any guesses?? http://www.diynot.com/network/afclucas/albums/

Thanks for the diagram, does it matter that I don't have a room thermostat? Would wiring it wrong mean that is why my Rads aren't getting warm? Mank thanks

I have two zone valves. One for water and one for CH. I notice however that the pump and CH valve were both working even though the programmer said CH was off. Could it be the wiring? Do you know where I can get the correct wiring diagram for Drayton ZA 5/679-2 (22mm) zone valve? Many thanks

My heating decided to stop working last Friday. I replaced my pump last year so I didn't think it was that, but I check it with the screw driver anyway and it is working fine. I then checked my 2 port zone valve, that wasn't working, so I brought a Drayton 2 port zone valve from B&Q, replace it...

My heating decided to stop working last Friday. I replaced my pump last year so I didn't think it was that, but I check it with the screw driver anyway and it is working fine. I then checked my 2 port zone valve, that wasn't working, so I brought a Drayton 2 port zone valve from B&Q, replace it...