Morning all.
Well im pleased to report that I'm getting the chance to practice of loads of old off cuts before I take it to my actual project.
As I learn more about routing I'm getting more used to the terms. Aside from t trim I'm also looking at cutting a channel on the face of the board to...
Hi JobandKnock,
Thank you for this, it's helpful to know the ranges and as newbie that I'm not plunging in at the to end of the market
I'll check out those other lines out of morbid curiosity! And no doubt feel my wallet leap out of my pocket and run for the hills!
Thanks Wgt52, I'm definitely getting started and Im looking to learn.
One thing I've noticed is that these 2mm slot cutters are quite expensive.
Does any one know of some good sites that stock it. Don't want the cheapest part but not sure if I'm paying over the odds
Hi Endecotp
Thanks so much for the quick reply and you explanation and links has helped me massively
So I'm looking at 1/4 router , so this bit would be a fit?
https://www.wealdentool.com/acatalog/Online_Catalogue_Knock_On_Edging_Groover_913.html
Yes definitely along the edges and that how...
Hi There,
Im hoping for some advice with regards to router and a slot cutter
I need to use a 2mm slot cutter to cut a slot for T moulding. So far so good
However, thus us my first step into routing and I'm more then happy to have a crack but I'm confused by all the different terms...