Recent content by alanframe

I checked all of the cylinder not just the top. I even cut a square out of the lagging above the coil connections but no luck. Looking like I'll need to swap my s flange for an essex and go down that route which I was trying to avoid. Thanks for the suggestions so far everyone.[/url]

It's a flexilag jacket on the cylinder which makes it hard to tell if it has a secondary. Or would there be an existing cutout in the jacket. Either way I cant see any other connection points.

It is indeed a gledhill cylinder. I did check for secondary outlets but other than the immersion outlet couldnt see any. I'll go and triple check but dont hold out much hope !

Theres no hex shank the body of the fitting is an orignal part of the tank and is brazed/welded in.

Hi I am fitting a salamander s flange to my hot water tank to connect my shower pump up. I have run across a problem though. The flange has a 1" male thread on the bottom and comes with a female adapter. I thought that the top of my water tank had a 1" male connector but after partially...