Recent content by Alex Terry

  1. A

    Doorbell Chime Casing - The immovable object

    Thanks John! Gave it a good go trying to lever with the screwdriver but I think it may have to just be a (carefully positioned) hammer to get in there (could only lever from that far down as the base is so tight you cant fit a screwdriver in there to lever it)
  2. A

    Doorbell Chime Casing - The immovable object

    Looking at the unit I'm not sure it's possible to get a screwdriver in there (see pics below) as it's right in the corner of the room I can get it in one side but it didnt seem to release anything
  3. A

    Doorbell Chime Casing - The immovable object

    Thanks for the advice! Unfortunately, those 2 clips don't seem to be doing anything, it appears to be directly in the corners where it's locked in place - the plastic flexes freely around those those 2 catches in the photo
  4. A

    Doorbell Chime Casing - The immovable object

    Hey John, Sadly not, seems to be smooth all the way around sadly
  5. A

    Doorbell Chime Casing - The immovable object

    Hi All! This may seem like an extremely stupid question but I wondered if you have any advice on how to get a doorbell chime/transformer casing cover off (picture attached). It looks like it should just pop off but it feels like I'm going to pull the entire unit off the wall before the casing...
  6. A

    Honeywell CM907 to Lyric T6

    Hi All, I'm trying to upgrade my existing Honeywell CM907 thermostat to a newer Honeywell Lyric T6 but can't quite figure out how to translate the wiring from one to the other. The wiring diagrams are attached - As you can see the CM907 has two wires going to it from the boiler but the T6 also...
Back
Top