Recent content by Alexiey

  1. A

    Dimmer Question Again (sorry)

    JJ10, The slave only has two connections, L and S so connect up the incoming 'LIVE' to L on the dimmer (thats normally the RED WIRE) and connect up either the BLUE or YELLOW wire to S on the SLAVE which incidentally goes to S on the MASTER The output from your MASTER should go to...
  2. A

    Trailing edge dimmer switch

    Hello, Try DANLERS or TLC
  3. A

    Installing New Range Cooker

    With regards a new RangeMaster cooker installation, you have to think, What is going to be my highest demand? Christmas, Birthdays, Special dinner parties etc when perhaps you have both ovens on going full warp 10 plus a few rings as well, in other words full demand on the circuit. What I...
  4. A

    Cable spec for Rangemaster cooker

    Dual fuel cookers can use 6mm cable but ALL ELECTRIC especially with INDUCTION hobs it is recommended 10mm^2 cable protected with a 45A RCB No way should this arrangement ever be connected directly to your 240v ring mains ie a 240v plug socket
  5. A

    Please help-Wiring Advice for a Rangemaster Induction Cooker

    Hello, I have been reading all the replies with great interest and I was surprised to see what some people had to say. The bottom line is I have just bought a RangeMaster Classic Induction Delux ALL ELECTRIC and the advice I got from the seller was to wire in using a 10mm cable...
  6. A

    HOOVER CLASSICA WASHING MACHINE

    Hello everyone, I own the above and the machine wont go into a spin cycle on Prog 4 BUT if you switch to HALF LOAD it does and its ok on other cycles. Could this be the selector?
See more
Back
Top