Recent content by Alexkak

So will not be able to use this function?? it saying this in the online manual 5.15.4 User SMS Signalling To signal via SMS, a valid mobile number and the desired event types must be programmed. SMS Details: Up to 10 mobile numbers can be programmed. User Mobile: The mobile phone where...

Hi, I am about to install a Pyronix enforcer system, before I unbox everything and go any further, can I setup the system to send SMS alerts to my personal mobile number using the PSTN dialler, or does this need to be something that is activated by affiliated installer? I only want to be able...

Hi Scott, So the resistor doesn't terminate in the bell box as described in the manual, I just need to connect it between the Z33 terminal and the end of the wire that is connected to C in the bell box (All termination is done in the control panel?) Also, another qq... the PSTN line only...

Hi, Thanks for the quick response, my system doesn't arrive until tomorrow, is it obvious where Zone 33 hardwire int will be on the back box, the installation guide diagram shows place the resistor between T and B- connections on the Bell Box, but doesn't mention anything about connecting to...

Hi, Could anyone advise on the installation of the of a Texecom external wired sounder to the Enforcer control panel, it mentions that I need a resistor? as below To create the bell tamper circuit, a resistor is required across 0V supply and tamper circuit of the bell box as shown in the...