Recent content by alig301

I ended up going for the 4G gsm-activate unit. It was easy'ish' to fit and seems to do the job well. Hopefully I wont need to test it in anger. Time will tell. I found the GSM active guys helpful so if there is an issue I am hopeful they would assist. Let me know if I can be any more of assistance

Spot on, that's what it was. It reset some settings when I took the power off. All the other settings looked like they remained. Not sure why only the bell delay went to 10 mins. Sorted now. Thank you both.

Guys, the saga continues. Since fitting the dialler and panic alarm, the system doesn't appear to work properly. When I set the full or part system, the system appears to set as normal and the control panel displays 'SET'.....(all good and get the right tones.) The problem is when a zone is...

cool I will give it a go tomorrow. Thanks for all the help

I have programmed it and loaded the numbers and the message. The last bit is the alarm to the dialler. I have the +12v and 0v, is it only one cable from the bell trigger to the dialler trigger?

ok all done and seems to work. Thank you all for your help. Now onto the dialler

To a separate input or can I connect it to one a PIR is connected to?

Ok so I have made progress, I have got it so there is lights on. So a couple of red LED and Segment is showing 'U' then 't'. Next step where do I connect the 2 NC Output A cables from the UR2 to on the alarm panel???. Bell or one of the PIR's??

There is 12v on the input terminals on the UR2-WE so I don't think it is the fuse. I can't see a fuse on the UR2

There doesn't seem to be any life to it when I connect the 12v There is nothing on the LED segment. I have tried moving all the dip switches and still nothing. I would have expected some sign of life with the 12 v connected.

So finally got around to trying to wire the UR2-WE, I have connected the 12v input but there doesn't seem to be any life. Is there something else that needs to be done. I expected the led digit to light in one form or another. Do I need this jumper. It doesn't seem to be in the box?

Anyone willing to help me wire the UR2-WE if I upload the alarm control panel pic please?

Thanks :)

How do I check the firmware on the receiver?

I assume you mean the receiver software version to be v4.03