Recent content by alix

Sorry wasn't in y/day...ok can you confirm if this is how it should be....at the switch the single red and black wires should go in to L1 and COM, and it doesn't matter which. The other wires are ok as they are.....then at the light all the red should go in to the loop terminal on their own the...

Ok, still can't get it to work......( or should i say not work because it is permanently on) and the thing is this is exactly as it was wired up before, so i did neglect to say that i have also changed the light from a single bulb to a three way spot light....have i connected this...

thanks mate, i'm going home now,i'll try it and let you know monday!

Thanks again, can you just confirm whether what i wrote in the last reply is right?

no connection as far as i can see. But i put red in L1 and black in Com (or other way round). Would the other affect it? How should that be wired...yellow in Com..2 red in L2...black and blue in L1?...i think that is the way i have it, i'm at work at moment and can't remember.

the one with just one set.

Thanks for the reply, being a bit thick, can't find the reference section on the site. But is it normal to have 2 sets of wires going in to one light and only 1 set going in to the other?

I am trying to change a two way switch to a 2 way dimmer..i thought that i replaced it as before but what has happened is one light works fine, the other is on all the time. The wiring is as follows: There were seven mains wires, one red one black went in to one of the switches (L1 and L2). The...