when I get hold of a sensor I will connect it to the programmer power it up and see if switching occurs through the HTG connection 4 on the programmer when I call for heat or not call for heat. I did put a multimeter on the sensor connections 5 and 6 to see if there was voltage I got some sort...
Thank you Stem for your help appreciated. At present, I do not have the sensor so I cannot see if I wire it to the programmer that when I either call for heat or turn off the heat power is either enabled to HTG connection 4 or disabled. When wired with a temporary 240v and no sensor connected...
hi, I have a Danfoss tp9000 with a remote sensor for the heating can anybody tell me how this programmer and sensor are wired to an S plan system using a Honeywell 10 terminal junction box?