so i need to take the back off the washing machine to get it out? Doesnt it just 'push and turn'?
if i need to get the back off then no problems, seems a lot of work involved to 'change it over'. If its whats needed then off it comes
thanks
andy
thanks rocks
The waste goes into the back of the machine at the top on the left. Looks like it needs to 'turn' to unlock, do i need to take the back off the washing machine to get acess to it?
andy
Hi all
Ive got the above washing machine, the problem i have is that mice have bitten through the waste pipe causing the water to go over the floor and not to the drain. Ive managed to get a replacement hose, just needed to know how to change them over?
Is it a case of pushing it in and...
Hi all
Just after some advice. Ive currently got a honeywell ST799 programmer and a honeywell DT200 room stat and wanted to change it to a wireless system. Would the honeywell cm927 be the way to go?
Basically ive got a couple of rooms in the house that get very cold and the room where...
Thanks Picasso
I did the same with the cylinder stat that i did with the room stat; turned it up and down so the stat clicked to turn the boiler on and off as per normal.
If either or both stats were incorreclty wired would they then blow the fused spur, rcd and programmer if they both...
Thanks Picasso
So by checking and ammending the wiring should sort this out? Why though would it run for a while and then blow? I had been testing the room stat by moving the dial to click on and off which would turn the boiler on and off
thanks
andy
Thanks Matt
Im pretty sure that the £ port valve is wired correctly as it works when either the heating or hot water is selected, or both.
I think it could be to do with the room stat as this works in reverse; ie 10degrees setting is 30 degrees, and 30 degrees setting is 10 degrees.
I...
Just spoke to the customer and the fused spur has gone, the rcd has tripped and the programmer is dead. I think maybe there is a bit more to it than the room stat
Its a danfoss RMT230 room stat. This was the only thing that wasnt right. I had to fit a new 3 port valve which operates ok, a pump and a cylinder stat.
Hi all
Fitted a danfoss room stat yesterday as a replacement for a honeywell room stat the was faulty. When i turned the room stat up to call for heat, boiler fired and ran normally. Got a call today that the fuse has blown after the boiler had been running for around 2 hours or so.
The...
Thanks Terry
I can sympathise with where your coming from as i too have had a customer or two say the same or when im on my way to the merchant google the part and then say it cost this much when the jobs done. I now dont tell them too much just i need to get some spares from the merchant...
im assuming theres a problematic one in Langham! :wink: Got a year before i go back and fine tune my technique. your certantly right, it wasnt nice to work on, and the customer thought he had a bit of knowledge as well and watched me like a hawk! Not what you need when you cant get the...