Recent content by andybag

Sorted!! There is a water supply pipe fixed in which I figured was to top up the pressure. Topped up to 1 bar and circulated system and now maintaining the 1 bar after a few top ups / rad vents. I can only assume the system is pretty good as I've never had to top up the pressure before. Thanks...

Thanks for the advice. I think we may have to look at replacing the entire thing soo by at the minute I just need to get it working again so we have some heat and hot water. We're not with BG and dont have boiler cover but are they still the best to call out? Should I call Potterton directly or...

The pressure is actually 0 now. Is this easy to increase and if so, how do I do it?

I've searched through the forum alot and although there are a lot of posts rasied about the lockouts on the Powermax 155x, very few of them seem to offer an answer or are followed up with an answer after the poroblem has been fixed. This is where I need your help please!! 1. The lockouts have...

Thanks Woody. That seems to be the same thinkg i'm hearing from a few people to be honest. Thanks again for your replies...

Thanks for your replies. I've spoke to Celcon and read the spec of the Celcon blocks and they're supposed to be more resistant to water ingress / frost damage than normal blocks. We're going to line the inside of the walls with protective covering to prevent the damp from that side.

We are building small garden walls to use as raised beds for planting. The footings have already been done (150mm deep concrete) and i'm going to use the lightweight Celcon Blocks. I'm only going 2 blocks high for most of it then 3 blocks in the corner. There are 2 walls 600mm apart running...