Still struggling with this - the above 'fix' didn't work
With the thermostat set to be on all the time at max heat, the boiler would never fully turn off - wasn't heating anything but sounded like a pump still doing something.
I'm now thinking a single channel Hive would have been much easier...
So after doing some more research, it looks like I might have to have a bit of a workaround for my setup?
I may have to leave the RX1/TP5001 installed - set the temp to max and timings for 'on all day' and then just let the Hive control the on/off.
like this thread -...
Just wondering if anyone can help with this one..
So my existing system (pre Hive) is a hot water cylinder with Air Source Heat Pump (Mitsubishi Ecodan). I have a Mitsubishi FTC2 controller / Danfoss cp715 Programmer / Danfoss RX1 and TP5001 for the room thermostat.
I have replaced the...